Question bank

Filter questions by subject, topic and difficulty. Open any question to answer it and see the explanation.

Clear

90 questions found · practise this subject as a set Show 20 · 50 per page

#	Question	Subject and topic	Difficulty
1	In the construction of an isometric scale, the true lengths are marked on a line inclined at what angle to th…	Engineering Graphics Isometric scale	Easy
2	The ratio of isometric length to true length is closest to which value?	Engineering Graphics Isometric scale	Easy
3	An edge of a block is 60 mm long and parallel to an isometric axis. What length should it be drawn in its iso…	Engineering Graphics Isometric scale	Medium
4	What is the angle between the true-length line and the isometric-length line in the construction of an isomet…	Engineering Graphics Isometric scale	Medium
5	Each edge of a cube in isometric projection is inclined to the plane of projection at about 35°16′. Why does …	Engineering Graphics Isometric scale	Hard
6	In isometric projection, the slant edges of a pyramid are best described as which kind of line?	Engineering Graphics Prisms and pyramids	Easy
7	Which method is commonly used to draw the base of a hexagonal prism in isometric projection?	Engineering Graphics Prisms and pyramids	Easy
8	A hexagonal base has sides of 25 mm. What are the true dimensions of the rectangle that just encloses it, wit…	Engineering Graphics Prisms and pyramids	Medium
9	A square pyramid with base side 40 mm and axis 60 mm stands on its base on the HP. How is its apex located in…	Engineering Graphics Prisms and pyramids	Medium
10	A student draws a cube of side 50 mm in isometric projection and shows all three visible faces as rhombuses w…	Engineering Graphics Prisms and pyramids	Hard
11	In isometric projection, a sphere of radius 30 mm appears as which shape?	Engineering Graphics Cone, cylinder, sphere and hemisphere	Easy
12	What is the side of the rhombus used to draw the ellipse for a circle of diameter 60 mm in isometric projecti…	Engineering Graphics Cone, cylinder, sphere and hemisphere	Easy
13	How are the outline (generator) lines of a cone drawn after the base ellipse and apex are fixed?	Engineering Graphics Cone, cylinder, sphere and hemisphere	Medium
14	In the four-centre method, which points are used as two of the four centres?	Engineering Graphics Cone, cylinder, sphere and hemisphere	Medium
15	A hemisphere of radius 30 mm rests on its flat face on the HP. Which statement about its isometric projection…	Engineering Graphics Cone, cylinder, sphere and hemisphere	Hard
16	A cylinder stands on its base on the HP. Along which isometric direction is its axis drawn?	Engineering Graphics Positions of solids	Easy
17	In isometric projection, a line that is perpendicular to the VP is drawn in which direction?	Engineering Graphics Positions of solids	Easy
18	A hexagonal prism lies on one of its rectangular faces on the HP with its axis perpendicular to the VP. On wh…	Engineering Graphics Positions of solids	Medium
19	A cone has its axis parallel to both the HP and the VP. Its base therefore lies parallel to which plane?	Engineering Graphics Positions of solids	Medium
20	A square pyramid stands on its base on the HP with two base sides parallel to the VP. How are the base edges …	Engineering Graphics Positions of solids	Hard